La-crosse-technology 3362 Manuel d'utilisateur

1Operating Manual COST CONTROL - POWER CONSUMPTION MONITOR Contents Introduction 1 Intended Use 2 Safety Precautions 3 The Cost Control

10Note: The appliance should be operated as normal, for hints on this see the “Extra Notes” section. 13. USING THE COST CONTROL: Using the Cost Con

11 When the monitoring of an electrical appliance is complete; simply turn the appliance off; remove the Cost Control from the outlet and the

12be reset to zero (as was done in Setting Up – step 11 above). 14. REPLACING THE BATTERIES: A low power battery usually reduces the contrast of the

1315. EXTRA NOTES: The electrical appliance connected to the Cost Control should always be operated as normal if forecasting of the cost is required

14 Example 1: A lamp is plugged into the Cost Control and operated every evening: Day 1 from 6:00p.m. to 8:00p.m. Day 2 from 7:00p.m. to 9:00p.m. Da

15recommended to keep the appliance plugged into the Cost Control for several days before taking the reading. If a reading is taken after the applia

1617. SPECIFICATIONS: • Absolute max. rating (short time) -Load : 1800W max 4W min -Current : 15A • Op

17• Damage caused by neglect, misuse or failure to comply with this manual will invalidate the warranty of this product. • The manufacturer cannot

18INFORMATION. THIS PRODUCT IS NOT A TOY. KEEP OUT OF CHILDRENS’ REACH. This warranty gives you specific legal rights. You may also have other rig

2you can fully take advantage of all the features it has to offer. 2. INTENDED USE: The Measuring range of the Cost Control is from approximately 3W

3In order to maintain perfect condition and guarantee safe operation of this product, the user must observe the Intended Use, Safety Precautions, and

4• In commercial institutions the safety regulations of the alliance of commercial professional association for electrical installations and product

54. THE COST CONTROL: LCD TARRIFF Key COST Key POWER Key Socket Battery Cover Plug

6 5. FEATURES: • Cost monitoring • Cost forecasting (day, month, year) • Instantaneous power consumption (Watt) • Maximum load power display (Ma

7When an electrical appliance is plugged into the Cost Control, by pressing the “POWER” key, the instantaneous power (Watts) being used at that preci

8• Any preset values in the “TOTAL COST” display that the user has not set in must be reset to zero to ensure accurate readings. To do this, simply

9 • Press and hold the “TARIFF” key (approximately 3 seconds) until the first digit on the right hand side starts flashing. • Press the “POWER” key