La-crosse-technology WS-8056U Manuel d'utilisateur

WS-8056U 433 MHz Radio Controlled Temperature Alarm Instruction Manual               

10B) THE ALARM 1) SETTING THE ALARM Note: The duration of the alarm is 85 seconds. After each of the first two 25 second periods, the rate of th

11C) INDOOR TEMPERATURE The indoor temperature appears on the right side of the date LCD. The temperature is checked every 10 seconds and updated

12V) MAINTENANCE & CARE • Extreme temperatures, vibrations, and shock should be avoided to prevent damage to the units. • Clean displays and u

13TROUBLESHOOTING Problem: The LCD is faint. Solution: 1) Replace the batteries. Problem: “OFL” appears in the indoor temperature LCD. Solution: 1) M

14SPECIFICATIONS FOR WS-8056U Temperature: Measuring range: 32°F to 122°F with 0.2°F resolution (indoor) -21.8°F to 140°F with 0.2°F resolution (outd

15 WARRANTY INFORMATION La Crosse Technology provides a 1-year warranty on this temperature alarm. Contact La Crosse Technology immediately upon d

16 FCC ID: OMO-01RX (receiver) THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: 1. THIS

2TABLE OF CONTENTS Topic Page Inventory of Contents/ Additional Equipment 3 About WWVB 3 Quick Set-Up Guide 4 Detailed Set-Up Guide Battery Instal

3INVENTORY OF CONTENTS 1) WS-8056U 2) TX6U remote temperature transmitter 3) Instruction manual and warranty card. ADDITIONAL EQUIPMENT (not in

4QUICK SET-UP GUIDE Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. 1. Have the temperature clock and remote temperatu

5DETAILED SET-UP GUIDE I) BATTERY INSTALLATION Note: To avoid start-up problems make sure that the batteries do not spring free. A) REMOTE TEMPE

6II) PROGRAM MODE To enter the program mode hold down the “SET” button for 2 seconds, until “-5EST” flashes in the date LCD. The program mode is la

7US English F French E Spanish C) DST (DAYLIGHT SAVING TIME) SETTING Note: The DST default is “On”, meaning that the WWVB will automatically change

8F) CALENDAR SETTING Note: When the WWVB signal is found, that date will over-ride the manually set date. 1) Hold down the “SET” button for 2 secon

9III) FEATURES & OPERATIONS A) CHANGING DISPLAY MODE (DAY, SECONDS, AND TEMPERATURE) There are three possible display modes to view the day,