La-crosse-technology WS-9124 Manuel d'utilisateur

1Contents Language Page _______________________________________________ English 1 French 47 Spanish WIRELESS 915 MHz TEMPERATU

10 RESETTING THE MINIMUM AND MAXIMUM READINGS: User may reset the minimum and maximum temperature / humidity data to the current value by

11received about 2 minutes after setup (the signal reception icon does not appear), please check the following points: 1. The distance of the Temper

12POSITIONING POSITIONING THE TEMPERATURE STATION: The Temperature Station comes attached with a table stand, which provides the option of table stan

13using the bracket which doubles as a stand or wall mount base. To wall mount: 1. Secure the bracket onto a desired wall using the screws and pla

14• Do not submerge the units in water. Place units in locations that are adequately protected against moisture and rain. • Immediately remove all lo

15approximately 12 months Dimensions (L x W x H) Temperature Station : 2.29" x 0.69" x 4.66" (58.2 x 17.6 x 118.4 mm) Tempera

16Crosse Technology, Ltd will pay ground return shipping charges to the owner of the product to a USA address only. Your La Crosse Technology, Ltd w

17 For warranty work, technical support, or information contact: La Crosse Technology, Ltd 2809 Losey Blvd. S. La Crosse, WI 54601 Phone: 608.782.1

2FEATURES: The Temperature Station • Quartz clock in 12 or 24-hour time display (hour and minute, manually set) • Indoor and outdoor te

3• Wall mounting case (Mount in a sheltered location. Avoid direct rain and sunlight) SETTING UP: When one sensor is used 1. First, insert the bat

4place, all segments of the LCD will light up briefly. Following time as 12:00 and the indoor temperature will be displayed. If they are not shown in

5If the signal reception is not successful on the first frequency (915MHz) for 45 seconds, the frequency is changed to 920MHz and the learning is tri

62. Insert the batteries, observing the correct polarity (see marking). 3. Replace the battery cover on the unit. Note: In the event of changing ba

7SET/CH key (Setting/Channel) • Press and hold for approximately 3 seconds to enter the Manual setting mode. • Press and release to toggle between di

8(“OFF” icon). On the other hand, the short blinking of the icon shows that a reception is being done at that time. For a better display clarity, th

9MANUAL TIME SETTING User shall manually set the time of the Temperature Station by the following steps: 1. The hour digit of the time display will