La-crosse-technology WS-9065TWC Manuel d'utilisateur

WS-9065TWC Wireless 433 MHz Radio-controlled Weather Station Instruction Manual

106. Press and release the SET button to confirm and advance to the day/month setting. 7. The day and month will flash in the date LCD. 8. Press

111. Press and hold the SET button for 5 seconds. 2. “LCD” will show in the time LCD and the number setting will flash. 3. Press and release the S

12Sunny—indicates that the weather is expected to improve (not that the weather will be sunny). Sun with Clouds—indicates that the weather is expecte

13 III. OUTDOOR TEMPERATURE The temperature received from the remote temperature sensor is viewed in the OUTDOOR LCD. When there is more than one re

142. Press the OUT button again (once while “MIN” is still displayed, twice otherwise). “MAX” appears above the outdoor temperature and the LCD will

154. In sequential order, install batteries (follow the same battery installation procedures seen in section I. A) of the Detailed Set-Up Guide). 5.

16I. THE REMOTE TEMPERATURE SENSOR The remote temperature sensor can be mounted in two ways: • with the use of screws, or • using the adhesive tap

17II. THE INDOOR WEATHER STATION The indoor temperature station can be mounted in two ways: • with the table stand or • on the wall

18Problem: No outdoor temperature is displayed. Solution: 1) Remove all batteries, reinsert into sender first, then display. 2) Place remote send

19SPECIFICATIONS Temperature measuring range: Indoor: 14.2°F to 139.8°F with 0.2°F resolution. (-9.9°C to 59.9°C with 0.1°C resolution). “OF.L” di

2TABLE OF CONTENTS Topic Page Inventory of Contents/Additional Equipment 3 About WWVB 3 Quick Set-Up Guide 4 Detailed Set-Up Guide Battery install

20WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and w

21For warranty work, technical support, or information contact: La Crosse Technology 2809 Losey Blvd. S. La Crosse, WI 54601 Phone: 608.782.1610 Fax

3INVENTORY OF CONTENTS 1. The indoor weather station (Figure 1). 2. One remote temperature sensor with mounting bracket (Figure 2). 3. Three eac

4QUICK SET-UP GUIDE Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. 1. Have the indoor weather station and remote temper

5DETAILED SET-UP GUIDE I. BATTERY INSTALLATION A. REMOTE TEMPERATURE SENSOR 1. Remove the mounting bracket. The bracket snaps on and off e

6PROGRAM MODE Programming Note: If 30 seconds is allowed to pass, or the CH button is pressed during the programming mode, the unit will confirm/set

74. Press and release the SET button to confirm and advance to the Time Zone setting. IV. TIME ZONE SETTING 1. Press and hold the SET button for

8“DST 0” indicates that the feature is off and the WWVB will not change times automatically. “DST 1” indicates that the feature is on and the WWVB wi

9VIII. TIME SETTING There are two methods by which the time and date can be set: A) Automatically via WWVB reception, or B) Manually. A. WWVB (R